Added M5 mesh system - do I need to alter Hub1?
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Plusnet Community
- :
- Forum
- :
- Help with my Plusnet services
- :
- My Router
- :
- Added M5 mesh system - do I need to alter Hub1?
Added M5 mesh system - do I need to alter Hub1?
26-06-2020 6:21 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Hello,
I have just bought a new TP link deco m5 setup, and have installed it. Somewhere in the back of my mind, I am sure I have to either change a setting, or disable something on the Hub1 to get it to work properly. I can’t get some devices to connect to The new m5 setup at all.
thanks
Dave.
Re: Added M5 mesh system - do I need to alter Hub1?
26-06-2020 9:46 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
You cannot properly use a Hub One unless you configure the M5 in Access Point mode. In this case you should turn off the Hub One WiFi.
Alternatively you need to swap the Hub One modem/router for a simple bridge modem such as a Huawei HG612.
Moderator and Customer
If this helped - select the Thumb
If it fixed it, help others - select 'This Fixed My Problem'
Re: Added M5 mesh system - do I need to alter Hub1?
29-06-2020 4:38 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Famous last words.
Thanks again.
Dave.
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Plusnet Community
- :
- Forum
- :
- Help with my Plusnet services
- :
- My Router
- :
- Added M5 mesh system - do I need to alter Hub1?