Technicolor tg582n remote access problem

[#1]

hi guys,

I'm still using this router in a remote locality with adsl.

The problem that i wish to resolve is about remote access.

Everytime the router is restarted the remote access change from enable to disable.

I have to reactivate the service manually.

Is There a way to solve this problem ? 

Plusnet firmware with

Software Release:

10.2.2.B

Thanks in advice

Genno

[#2 · Accepted solution]

Hi @billwiller80 welcome to the forum

Are you enabling remote access via the GUI or via telnet?

If I recall when I had one of these devices when using telnet to make changes a saveall command was required to make the change permanent.

Dan

[#3]

hi dan,

after a saveall in telnet the service keep enabled even after the router turns off/on.

Thanks !