Printer not accepting password/key

Townman · ‎22-08-2007

Hub 1 to Hub 2 change, old printer - I’d be looking at a/b/g mode compatibility. Would need to check the printers wifi spec. Try changing the mode. Also check the printers WAP support - by default the Hub2 uses WAP2.

In another browser tab, login into the Plusnet user portal BEFORE clicking the fault & ticket links

Superusers are not staff, but they do have a direct line of communication into the business in order to raise issues, concerns and feedback from the community.

If this post helped, please click the Thumbs Up and if it fixed your issue, please click the This fixed my problem green button below.

Pete11 · ‎17-02-2017

I had run out of patience (and temper), but the issue seems to be solved/fixed. I did a clean install of the drivers and YESSS, printer is working. It seemed to be either a port problem or was looking for a wired connection which I don't have.

Thanks to all who gave advice/help/solutions, now I'll go and count how many more grey hairs I've got.

Thanks all.

A float tip is pleasing in its appearance and even more pleasing in its disappearance.
Growing old is inevitable...But growing up is optional.

Townman · ‎22-08-2007

That solution is confusing. Do not see how updating the printer driver on the PC altered the printer’s ability to connect to the hub properly.

None the less, this being fixed for you is good .

In another browser tab, login into the Plusnet user portal BEFORE clicking the fault & ticket links

Superusers are not staff, but they do have a direct line of communication into the business in order to raise issues, concerns and feedback from the community.

If this post helped, please click the Thumbs Up and if it fixed your issue, please click the This fixed my problem green button below.

Pete11 · ‎17-02-2017

I can't understand it either, but, the clean install seems to have done the job.

A float tip is pleasing in its appearance and even more pleasing in its disappearance.
Growing old is inevitable...But growing up is optional.