Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
DLM Reset
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Plusnet Community
- :
- Forum
- :
- Help with my Plusnet services
- :
- Full Fibre
- :
- DLM Reset
DLM Reset
3 weeks ago
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Hello
I have had Plusnet FTTC for a while after switching from TalkTalk and the speed had always remained stable until a few days ago, the hub suddenly turned orange and went on a loop of resetting every few minutes for a couple of hours. The diagnostic bot found a fault with the line but when I tried calling I couldn’t get through to anyone. Is it possible to have the DLM reset as the speed has now plummeted down to less than half what I was getting previously and most services like Netflix are now unusable due to constant buffering
Thanks
I have had Plusnet FTTC for a while after switching from TalkTalk and the speed had always remained stable until a few days ago, the hub suddenly turned orange and went on a loop of resetting every few minutes for a couple of hours. The diagnostic bot found a fault with the line but when I tried calling I couldn’t get through to anyone. Is it possible to have the DLM reset as the speed has now plummeted down to less than half what I was getting previously and most services like Netflix are now unusable due to constant buffering
Thanks
2 REPLIES 2
Re: DLM Reset
3 weeks ago
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
You clearly have a fault-use the bot to report it: https://www.plus.net/help/report-a- problem/
Plusnet Hub2WiFi Hub IPv6 Status:Enabled IPv6 network status:Disabled
IPv6 WAN detailsGlobal unicast address:Not availableGlobal unicast prefix / length:Not availableLink local address:Not availableRemote link local address:Not availableDNS:IPv4 only
GUI version:1.9 16_08_2022
Firmware version:v0.10.00.04201-PN
IPv6 WAN detailsGlobal unicast address:Not availableGlobal unicast prefix / length:Not availableLink local address:Not availableRemote link local address:Not availableDNS:IPv4 only
GUI version:1.9 16_08_2022
Firmware version:v0.10.00.04201-PN
Re: DLM Reset
3 weeks ago
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
@Bond02 If the bot found a fault - what was the fault, and what was the suggested course of action? A DLM reset without a fault resolution is pointless.
John
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page