Unifi UDR on FTTP

[#1]

I thinking of moving from my Hub 2 to a Unifi UDR router but before I do this have any of you tested compatibility using PPoE? I understand the settings that are needed but just confirmation before I make this leap.

[#2]

I haven't used a Unifi UDR but third party routers are fine with Plusnet.

The obvious questions are full fibre or not?

If full fibre then plug the UDR into the Openreach ONT.(note no VLAN settings for the WAN connection needed, the ONT handles that)

If not then the Hub 2 can be set into bridge mode.

PPPoE requires more from the router than a DHCP connection but my guess is that the Unifi UDR router would be up to it.

[#3]

@markhawkin The title of the thread answers your question of whether the connection is FTTC or FTTP.😀