cancel
Showing results for 
Search instead for 
Did you mean: 

Hub 2 unable to bridge to Deco E4

Jimmyj
Newbie
Posts: 2
Registered: ‎12-12-2023

Hub 2 unable to bridge to Deco E4

Had been working perfectly fine with TP-Link deco E4 wired connection. Hub2 in bridge mode.

Have reset both hub 2 and deco but Deco is unable to reach internet and hub2 is not recognising the device

Have replaced the ethernet cable with one known to work

Any suggestions
2 REPLIES 2
Jimmyj
Newbie
Posts: 2
Registered: ‎12-12-2023

Re: Hub 2 unable to bridge to Deco E4

Correction S4 not e4
MisterW
Superuser
Superuser
Posts: 15,991
Thanks: 6,045
Fixes: 437
Registered: ‎30-07-2007

Re: Hub 2 unable to bridge to Deco E4

hub2 is not recognising the device

@Jimmyj not sure what you mean by that ?

However, first check that the Hub 2 is actually in bridge mode , its LED should be pink. Then you will need to set the DECO internet connection type as PPPoE and enter your Plusnet username & password. Username is your accountname followed by @plusdsl.net and password is the one used to login to the member centre.

 

 

Superusers are not staff, but they do have a direct line of communication into the business in order to raise issues, concerns and feedback from the community.