Plusnet IPv6 High Touch Trial Launch

[#1]

Thanks everyone, really appreciate it. Going to cap number of applicants there so I can get the change written to add the IPv6 addresses.

I'll start a new thread next week when we're ready to go.

After that will be getting everyone online, Hub 2 should be straightforward as I think it's enabled out of the box so should just need a disconnect/reconnect. I've not personally tried it on any other routers yet but it sounds like we have a good variety.

[#2]

---

@dave wrote:

I've not personally tried it on any other routers yet but it sounds like we have a good variety.

---

Yeah, I think that will be a particularly interesting side of this.

Whilst you (PN) can't be expected to provide official support to non-supplied routers, perhaps a user-developed thread on this forum could be created that captures the steps required to enable and configured IPv6 on different models? It will unlikely cover every possible model out there, but even if it ends up just covering a variety of makes it could still serve a useful stepping stone for those that might not know where to even start.

[#3]

Moderators Note

The trial is currently full, should more spaces become available it will be mentioned in this thread.