cancel
Showing results for 
Search instead for 
Did you mean: 

Removing redundant OpenReach Master Socket

KDPN2015
Dabbler
Posts: 18
Thanks: 2
Fixes: 1
Registered: ‎21-12-2015

Removing redundant OpenReach Master Socket

Moved over to fibre in June. No longer a dialing tone when plugging a phone into the OpenReach Master Socket. It's installed in a flat and the twisted pair incoming cable is accessible inside a junction box in the flat. Thinking of cutting the two wires in that box, insulating off and then removing the Master Socket and twisted pair cable to it from the said junction box. Am competent at electrics so should not technically be an issue. Is it legal to do this now or after 31st Jan?
4 REPLIES 4
ExForce9
All Star
Posts: 688
Thanks: 355
Fixes: 11
Registered: ‎04-07-2026

Re: Removing redundant OpenReach Master Socket

@KDPN2015 

The official way to do that is visit this website -

        https://www.openreach.com/building-developers-and-projects/altering-our-network 

complete the form accessible via that page or directly here - https://openreach.my.salesforce-sites.com/form/?NRV 

and request that Openreach remove your landline cable and master socket.

Forum members who have done that have reported that Openreach will phone you back to arrange an appointment, and then an engineer will come and to do the work typically within seven days, and from reports so far this has cost nothing (other than your time).

.

KDPN2015
Dabbler
Posts: 18
Thanks: 2
Fixes: 1
Registered: ‎21-12-2015

Re: Removing redundant OpenReach Master Socket

Thank you!
Jones
Grafter
Posts: 43
Thanks: 19
Registered: ‎21-05-2025

Re: Removing redundant OpenReach Master Socket

@KDPN2015 ,

I cut the copper cable where it enters our house and used the BT master socket to feed an upstairs extension socket where I've got a DECT phone base plugged in.

Nobody came knocking at our door 🙂.

HPsauce
Aspiring Champion
Posts: 7,425
Thanks: 456
Fixes: 5
Registered: ‎02-02-2008

Re: Removing redundant OpenReach Master Socket

I reverted ours back to an early 1980s old-school smaller LJU style BT socket surface-mounted on a recessed box, just for amusement really (because I had one). 🤣

Got the old massive surface-mounted NTE5A and thick faceplate out of the way and looks tidy and suitably "vintage". And is still connected if BT ever turn up.

I was tempted to reinstall the original 1960s GPO jack sockets that were there when we moved here - previous occupants had multiple handsets, Plan 4 I think it was called then. But they are a bit bulky and I don't think I have a white/cream one, just brown.