Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Trying to install openWRT on a HH5 wont boot into CFG 04
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Plusnet Community
- :
- Forum
- :
- Other forums
- :
- Tech Help - Software/Hardware etc
- :
- Re: Trying to install openWRT on a HH5 wont boot i...
Trying to install openWRT on a HH5 wont boot into CFG 04
20-03-2017 2:10 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Trying to install openWRT on a HH5 wont boot into CFG 04.
When I ground boot selector 2, the router does nothing and when I disconnect boot selector 2 the router boot to CFG 06.
Soldered TX,RX and GND please see attached image.
Using Raspberry PI GPIO
1 REPLY 1
Re: Trying to install openWRT on a HH5 wont boot into CFG 04
20-03-2017 2:12 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Pi an hh5
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Plusnet Community
- :
- Forum
- :
- Other forums
- :
- Tech Help - Software/Hardware etc
- :
- Re: Trying to install openWRT on a HH5 wont boot i...