Adding static routes to 2704n... Or enable ssh??
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Plusnet Community
- :
- Forum
- :
- Other forums
- :
- Tech Help - Software/Hardware etc
- :
- Adding static routes to 2704n... Or enable ssh??
Adding static routes to 2704n... Or enable ssh??
30-05-2016 7:57 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Hi
I was just wondering if anyone knows how to add static routes to the plus net 2704n. Ideally without replacing the firmware.
An alternative would be to enable telnet/ssh.
Anyone know if away of doing this?
dlm
Re: Adding static routes to 2704n... Or enable ssh??
30-05-2016 8:26 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
I know for certain the Telnet/SSH functionality is disabled and by design cannot be re-enabled in the Plusnet firmware. Not really had too many dealings with the 2704n but I know there are some extra config options if you go to 192.168.1.254/expert_user.html
Re: Adding static routes to 2704n... Or enable ssh??
31-05-2016 6:42 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
See also this thread on this board. There are a few other helpful threads around. I'll try and find a few links. Note that the firmware v2 does not allow the config to be downloaded in text format
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Plusnet Community
- :
- Forum
- :
- Other forums
- :
- Tech Help - Software/Hardware etc
- :
- Adding static routes to 2704n... Or enable ssh??