cancel
Showing results for 
Search instead for 
Did you mean: 

New FTTP installation

FIXED
ToeKnee60
Grafter
Posts: 63
Thanks: 3
Registered: ‎06-12-2013

New FTTP installation

When the engineer installed my fibre connection from the telegraph pole and ONT today he left the old copper line from the pole to the telephone socket and told me it was so it could be used as a backup in case of problems with the fibre installation.
We don't have a landline.

Presumably in the near future it will be disconnected from the exchange. How long is that likely to be?

The reason that I ask is once I know it is no longer live I plan to remove the old telephone wire from the front of the house and inside the house to make it look tidier.

He also said it may take a few days for the connection to settle. I have done a few speed tests ant it varied between 495Mbs and 397 Mb/s down and between 60 Mbs and 45 Mb/s up. I have the 500Mbs service.
How long is the settling period?

21 REPLIES 21
Shep41
Seasoned Pro
Posts: 472
Thanks: 173
Fixes: 7
Registered: ‎31-05-2017

Re: New FTTP installation

With full fibre there is no settling period, you will get full speed straight away
Anonymous
Not applicable

Re: New FTTP installation


@ToeKnee60 wrote:

 

... told me it was so it could be used as a backup in case of problems with the fibre installation.

 

That seems a sensible thing to do, as there have been a few reported FTTP installations that fail in the first few days, with no way of reverting back in cases where the copper wires were removed.

 

 


@ToeKnee60 wrote:

 

Presumably in the near future it will be disconnected from the exchange. How long is that likely to be?

 

It is unlikely that your wires will be disconnected in the exchange before decommissioning from 2027 to 2035.

Even with the analogue phone system closing at the end of 2025, and all FTTC lines converted to SoGEA, the wires will remain connected in the exchange, even though the VDSL broadband signal comes from the roadside FTTC cabinet.

 

 


@ToeKnee60 wrote:


He also said it may take a few days for the connection to settle. ... ... How long is the settling period?


 

I would think that your physical connection has settled already, but account related IP profiles might take a day or two to be applied by Openreach and Plusnet.

jab1
Legend
Posts: 19,149
Thanks: 6,290
Fixes: 289
Registered: ‎24-02-2012

Re: New FTTP installation

That seems a sensible thing to do, as there have been a few reported FTTP installations that fail in the first few days, with no way of reverting back in cases where the copper wires were removed.

My understanding is that once you have been connected to FTTP, the FTTC connection is removed, and there is no way of going back. I may be wrong, and am happy to be corrected. You may still have the physical copper left in place, but it no longer has a signal.

@ToeKnee60 Be very careful about 'removing the old telephone wire from the front of the house,,,,,' - that is OpenReach's property, and you are not allowed to play with it.

John
Baldrick1
Moderator
Moderator
Posts: 12,392
Thanks: 5,569
Fixes: 430
Registered: ‎30-06-2016

Re: New FTTP installation

Moderator's note:
Thread moved from Fukk Fibre to My Order

Moderator and Customer
If this helped - select the Thumb
If it fixed it,  help others - select 'This Fixed My Problem'

Ian06
Aspiring Pro
Posts: 188
Thanks: 108
Fixes: 4
Registered: ‎06-04-2021

Re: New FTTP installation

Fix

I saw this a little while back on ISPReview: Remove Copper Line

So it looks like you can request the cable be remove when you are happy you no longer want it.

MisterW
Superuser
Superuser
Posts: 16,249
Thanks: 6,218
Fixes: 447
Registered: ‎30-07-2007

Re: New FTTP installation

If the exchange is 'Fibre priority' then there's no point in retaining the copper wire, Openreach won't accept an order for any service using it!!.

Superusers are not staff, but they do have a direct line of communication into the business in order to raise issues, concerns and feedback from the community.

jgb
Champion
Posts: 889
Thanks: 572
Fixes: 22
Registered: ‎01-08-2007

Re: New FTTP installation

Looking at it another way, if the copper wire and master socket are redundant following full fibre install why should the householder be left with the socket rather than it being removed as part of the full fibre install (assuming it is a service installed by Openreach) ? When we upgrade to full fibre the ONT will need to go where the master socket is - the external duct terminates just outside that point, the existing drop wire comes through the wall there, and there are mains sockets adjacent and we do not want the old socket cluttering things up.

jab1
Legend
Posts: 19,149
Thanks: 6,290
Fixes: 289
Registered: ‎24-02-2012

Re: New FTTP installation

In your specific case, @jgb I suspect the ONT will go where the master socket is currently, but there are instance, like mine, where the MS is located well away from the fibre entry point, and I may ask the installers if they can remove it, although there then remains the inside cabling - which runs halfway across the house through skirting, door frames and a wall.

John
Batfrog
Aspiring Pro
Posts: 121
Thanks: 61
Registered: ‎13-06-2023

Re: New FTTP installation

@ToeKnee60 Curious thing this not removing the old copper wire. As has been said it’s totally redundant, even if the FTTP should fail – at least that’s what I understand.

I went from FTTC to FTTP a couple of months ago. When the engineer arrived I said  “I’ll tell you what I want and you tell me what I can have”. We soon reached a compromise and the job was soon completed.

FOUR of my immediate neighbours have both copper and fibre going to their properties – totally pointless (I think) as at least two of them I know don’t have landlines PSTN or even VOIP.

I asked the engineer (as part of what I wanted) if he could remove the old copper pointing out how unsightly the telegraph pole was. “No problem” he said I’ll cut it off and use the existing bracket for the fibre. When I asked why the others hadn’t been removed he shrugged and said “idle B%**!$s, can’t be bothered, I’ve got to go up the pole anyway so why not”

I didn’t want a new bracket on the eaves a foot from the existing and two ‘cables’ like one of my near neighbours.

Since then I’ve become a bit obsessed, walking around the neighbourhood looking just how many properties have more than one ‘cable’.

Yes, Yes I know about 5th September last but I don’t think that explains them all !!

ToeKnee60
Grafter
Posts: 63
Thanks: 3
Registered: ‎06-12-2013

Re: New FTTP installation

The guy who installed it was a subcontractor from a company called Kelly Group. He said that they normally leave the old connection as a backup, so now I have 2 cables from the telegraph pole to different points on the front of my house.
He made a neat looking job of the install, but I am now left with redundant cabling outside and inside the house.

Thanks @Ian06  for the link to the ISPreview article. I will probably leave it a month then contact Openreach to remove the redundant copper cable if it is going to be free of charge.
Does anyone know how to contact Openreach to request this?

@jab1 The ONT is on the front wall almost behind the outside box. The telephone master socket is on a different wall about 2m away.
@MisterW our exchange is not a "fibre priority" exchange.

greygit1
Aspiring Pro
Posts: 411
Thanks: 56
Fixes: 1
Registered: ‎26-06-2023

Re: New FTTP installation

Copper has a scrap value worth. Accrue enough of it and off to the local metal recycler.

Admittedly, stripping off the plastic casing can be time consuming. But there are tools.

(I once 'upset' a central heating installer by removing all the stripped out copper - and brass - and took it to a local metal recycler. There was nothing in their install contract that specifically included them having to have exclusive access to the stuff they stripped out.)

RobPN
Seasoned Hero
Posts: 5,238
Thanks: 2,758
Fixes: 13
Registered: ‎17-05-2013

Re: New FTTP installation


@ToeKnee60 wrote:

The guy who installed it was a subcontractor from a company called Kelly Group. He said that they normally leave the old connection as a backup, so now I have 2 cables from the telegraph pole to different points on the front of my house.
He made a neat looking job of the install, but I am now left with redundant cabling outside and inside the house.


Kellys operatives (and presumably those from other subcontractors) get paid a fixed amount per job, so to remove the copper wire would take extra time which could be used more profitably elsewhere.  The amount they get paid doesn't compare with the way OR staff are paid.

jab1
Legend
Posts: 19,149
Thanks: 6,290
Fixes: 289
Registered: ‎24-02-2012

Re: New FTTP installation


@ToeKnee60 wrote:



@jab1 The ONT is on the front wall almost behind the outside box. The telephone master socket is on a different wall about 2m away.


Doesn't matter where it is, it is still the property of OpenReach.

John
ToeKnee60
Grafter
Posts: 63
Thanks: 3
Registered: ‎06-12-2013

Re: New FTTP installation

Thats why I was proposing to contact Openreach to ask if they can remove the old redundant connection from the telegraph pole and down the front of the house.
Do you know how I can contact then directly or do I need to go via Plusnet customer services?