no response to 10 echo requests
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Plusnet Community
- :
- Forum
- :
- Help with my Plusnet services
- :
- Fibre Broadband
- :
- Re: no response to 10 echo requests
no response to 10 echo requests
08-06-2015 6:19 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
only put the first few lines on as there is loads of lines
router dsl n66u
2015-06-08 11:11:59 syslog: No response to 10 echo-requests
2015-06-08 11:11:59 syslog: Serial link appears to be disconnected.
2015-06-08 11:11:59 syslog: Connect time 1487.4 minutes.
2015-06-08 11:11:59 syslog: Sent 26171004 bytes, received 103292548 bytes.
2015-06-08 11:11:59 syslog: LCP down.
2015-06-08 11:12:00 kernel: Link State: PVC_8_0 logistic interface down.
2015-06-08 11:12:01 WAN Connection: Fail to connect with some issues.
2015-06-08 11:12:01 stop_nat_rules: apply the redirect_rules!
2015-06-08 11:12:05 syslog: Connection terminated.
2015-06-08 11:12:05 syslog: Modem hangup
2015-06-08 11:12:05 syslog: LCP down.
anyone know what causes this
Re: no response to 10 echo requests
09-06-2015 10:55 AM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
2015-06-08 21:08:50 kernel: Link State: PVC_80 PPPoE down.
2015-06-08 21:08:50 kernel: Link State: DSL link down.
2015-06-08 21:08:55 WAN Connection: Ethernet link down.
2015-06-08 21:08:55 stop_nat_rules: apply the redirect_rules!
2015-06-08 21:09:17 kernel: Link State: DSL link up.
2015-06-08 21:09:21 WAN Connection: link up.
2015-06-08 21:09:27 syslog: Modem hangup
2015-06-08 21:09:27 kernel: tc3262_ptm_close
2015-06-08 21:09:27 syslog: Connect time 283.0 minutes.
2015-06-08 21:09:27 syslog: Sent 9493401 bytes, received 46441204 bytes.
2015-06-08 21:09:27 syslog: Connection terminated.
2015-06-08 21:09:27 syslog: LCP down.
not been good since the fault on the phone line(no dial tone) was fixed
could some one check the line again please
Re: no response to 10 echo requests
09-06-2015 3:59 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Re: no response to 10 echo requests
09-06-2015 4:48 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
raised a fault
Re: no response to 10 echo requests
11-06-2015 12:53 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Re: no response to 10 echo requests
11-06-2015 3:13 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Re: no response to 10 echo requests
11-06-2015 4:43 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Profile Name
0.128M-22.4M Downstream, Interleaving High - 0.128M-0.8M Upstream, Interleaving On
Time Stamp
2015-05-29T12:45:00
I see interleaving is on high
Re: no response to 10 echo requests
11-06-2015 5:24 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Re: no response to 10 echo requests
20-06-2015 12:44 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Used to be able to get 38mb then dropped ton 35 but since bt man snapped wire to phone 05/05/15 and other faults since dropped another 10mb
speed on 04/05/15
http://www.thinkbroadband.com/speedtest/button/143073941941824073840.png
speed now 25mb 20/06/15
http://www.thinkbroadband.com/speedtest/button/143480211625629739413.png
if it keeps going at this rate it will be quicker on adsl+2
Re: no response to 10 echo requests
22-06-2015 10:40 AM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Re: no response to 10 echo requests
23-06-2015 10:17 AM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
http://www.speedtest.net/my-result/4452971540
might change router see if that makes any difference
noise level up
SNR Down
9.0 dB
SNR Up
6.7 dB
the down one is normally at 6 or below
Re: no response to 10 echo requests
23-06-2015 3:43 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
had loads of these
Jun 23 15:00:58 FIREWALL icmp check (1 of 1): Protocol: ICMP Src ip: 187.90.46.152 Dst ip: 87.112.143.168 Type: Destination Unreachable Code: Port Unreacheable
Error Jun 23 14:57:19 FIREWALL icmp check (1 of 1): Protocol: ICMP Src ip: 58.216.206.174 Dst ip: 87.112.143.168 Type: Destination Unreachable Code: Port Unreacheable
Error Jun 23 14:19:21 FIREWALL icmp check (1 of 1): Protocol: ICMP Src ip: 83.147.183.141 Dst ip: 87.112.143.168 Type: Time Exceeded Code: Time to Live exceeded in Transit
this is just a few of them
Re: no response to 10 echo requests
24-06-2015 12:32 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Re: no response to 10 echo requests
24-06-2015 2:16 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Test Outcome Fail
Test Outcome Code GTC_FTTC_SERVICE_1625
Description Impairment in copper joint detected most likely in local network. Please continue to submit a trouble report
Main Fault Location LN
Sync Status In Sync
Downstream Speed 25.0 Mbps
Upstream Speed 4.7 Mbps
Appointment Required N
Fault Report Advised Y
NTE Power Status PowerOn
Voice Line Test Result Pass
Bridge Tap Not Detected
Radio Frequency Ingress Not Detected
Repetitive Electrical Impulse Noise Not Detected
Cross Talk Not Detected
Profile Name 0.128M-32.4M Downstream, Interleaving High - 0.128M-5M Upstream, Error Protection Off
Time Stamp 2015-06-11T14:00:00
Parameters MIN MAX AVG
Down Stream Line Rate 0.0 Mbps 30.3 Mbps 28.6 Mbps
Up Stream Line Rate 0.0 Mbps 4.9 Mbps 4.9 Mbps
Up Time 418.0 Sec 900.0 Sec 886.9 Sec
Retrains 0.0 3.0 0.0
so hopefully if it gets fixed speed should go back up
Re: no response to 10 echo requests
25-06-2015 5:28 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
he reset the line speed back up to 42 download where it was before but on doing speed test no difference
will I have to wait for it to kick in
1. Best Effort Test: -provides background information.
Download Speed 22.92 Mbps
0 Mbps 40.62 Mbps
Max Achievable Speed
Download speedachieved during the test was - 22.92 Mbps
For your connection, the acceptable range of speedsis 28.44 Mbps-40.62 Mbps .
Additional Information:
IP Profile for your line is - 40.62 Mbps
2. Upstream Test: -provides background information.
Upload Speed 4.85 Mbps
0 Mbps 20 Mbps
Max Achievable Speed
Upload speed achieved during the test was - 4.85Mbps
Additional Information:
Upstream Rate IP profile on your line is - 20 Mbps
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Plusnet Community
- :
- Forum
- :
- Help with my Plusnet services
- :
- Fibre Broadband
- :
- Re: no response to 10 echo requests