Path Mode Interleave in a new vdsl circuit

[#1]

Hi i just been upgraded from adsl to vdsl2 a few hour ago, i am using a Draytek 2860ln router.

since the switchover today i get max sync speeds , but any speedtest i run it is around the 15 mbit up/ 55-60 mbit down range

looking my dsl stats (attached)

path mode shows interleave with

ATU-R Information
	Type:	ADSL2/2+
	Hardware:	Annex A
	Firmware:	05-07-06-0D-01-07
	Power Mngt Mode:	DSL_G997_PMS_L0
	Line State:	SHOWTIME
	Running Mode:	17A
	Vendor ID:	b5004946 544e0000
ATU-C Information
	Vendor ID:	b5004244 434da4a1 [BDCM]
Line Statistics
	Downstream             Upstream                 Actual Rate 80000 Kbps 19999 Kbps Attainable Rate 101298 Kbps 35074 Kbps Path Mode Interleave Fast Interleave Depth 1284 1 Actual PSD 0. 4 dB 13. 8 dB       Near End                  Far End                    Trellis ON ON Bitswap ON ON ReTx 0   0   SNR Margin 7 dB 15 dB Attenuation 11 dB 13 dB CRC 7 32 FECS 4203 s 155 s ES 1 s 8 s SES 0 s 1 s LOSS 0 s 0 s UAS 30 s 214063 s HEC Errors 0 0 RS Corrections 0 0 LOS Failure 0 0 LOF Failure 0 0 LPR Failure 0 0 NCD Failure 0 0 LCD Failure 0 0 NFEC 254 73 RFEC 16 16 LYSMB 5374 25779

Is there anything i can do to improve it or do we have to get openreach to come back and do something at the cabinet that is an arm length away from my property

[#2]

Hi @ronnieshamash,
It is normal for DLM on a new VDSL circuit to default to interleaving.
Give DLM a few days to check the error rates on the line and all being well it should change to fast path.
As you posted a couple of days before I replied DLM may have alreday acted.
Regards
Richard