cancel
Showing results for 
Search instead for 
Did you mean: 

Saving defaults on the TG582n

adthelad
Dabbler
Posts: 12
Registered: 23-03-2011

Saving defaults on the TG582n

I am running this with firmware 10.2.2.9. I have tried to set the following but some return to the default settings:
Under Home Network
Wireless Power Save . Default is on but I want off
WPS: Default on but I want off
Encyption, Default WPA-PSK and WPA2-PSK but I want WPA2-PSK only.
DHCP scope: ...54 to ...253 as default but I want ...1 to ...100
SSID default is plusnetxxxxxx I want xxxxxx
After a reboot (not reset) these settings revert to default. Am I going to have to do a config backup and restore everytime I reboot the modem?
Regards
Adam.
4 REPLIES
Superuser
Superuser
Posts: 9,129
Thanks: 535
Fixes: 46
Registered: 06-04-2007

Re: Saving defaults on the TG582n

Did you click the "Apply" button after making the changes?
David
adthelad
Dabbler
Posts: 12
Registered: 23-03-2011

Re: Saving defaults on the TG582n

Yes I did, at all times.
Adam
brueton
Grafter
Posts: 308
Thanks: 5
Registered: 03-07-2009

Re: Saving defaults on the TG582n

Have you tried with 10.2.0.B?
I am having the same problem with being unable to save the wireless settings using 10.2.2.9 and have put it down to 10.2.2.9 being BETA software.
PeteB
adthelad
Dabbler
Posts: 12
Registered: 23-03-2011

Re: Saving defaults on the TG582n

As far as I can see, neither 10.x versions are production. They both have "demo" watermarked on the interface. However, I can confirm your findings. The user defaults are saved on V 10.2.0  without problem and you gain the wireles auto channel selection.
A.