IP Profile - 88.2% method
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Plusnet Community
- :
- Forum
- :
- Help with my Plusnet services
- :
- Broadband
- :
- Re: IP Profile - 88.2% method
Re: IP Profile - 88.2% method
03-10-2011 9:08 AM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Hopefully this means that in future we should all be able to recover faster from a low speed synch event - unless of course the DLM still responds by raising the target SNR?
Re: IP Profile - 88.2% method
03-10-2011 1:14 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Are you using the test socket, or extension socket/cable?
Jojo
Re: IP Profile - 88.2% method
03-10-2011 1:31 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
I have changed the profile on our side to 6500 to allow for the increased IP profile from your speed test.
Jojo
Re: IP Profile - 88.2% method
03-10-2011 9:48 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Re: IP Profile - 88.2% method
03-10-2011 10:35 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
in master socket as always.
podman
Re: IP Profile - 88.2% method
04-10-2011 9:40 AM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
@ Podman, Test socket or master socket?
Re: IP Profile - 88.2% method
04-10-2011 11:39 AM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
BT speedtest result:
Test1 comprises of two tests
1. Best Effort Test: -provides background information.
Download Speed
1113 Kbps
0 Kbps 2000 Kbps
Max Achievable Speed
Download speedachieved during the test was - 1113 Kbps
For your connection, the acceptable range of speeds is 800-2000 Kbps.
Additional Information:
Your DSL Connection Rate :2336 Kbps(DOWN-STREAM), 384 Kbps(UP-STREAM)
IP Profile for your line is - 2060 Kbps
2. Upstream Test: -provides background information.
Upload Speed
314 Kbps
0 Kbps 384 Kbps
Max Achievable Speed
>Upload speed achieved during the test was - 314 Kbps
Additional Information:
Upstream Rate IP profile on your line is - 384 Kbps
We were unable to identify any performance problem with your service at this time.
It is possible that any problem you are currently, or had previously experienced may have been caused by traffic congestion on the Internet or by the server you were accessing responding slowly.
If you continue to encounter a problem with a specific server, please contact the administrator of that server in the first instance.
Please visit FAQ section if you are unable To understand the test results.
Notes:
The Download Speed is the average rate that was achieved during this test.
Notes:
Your line is configured to the maximum rate that it can support or at your chosen fixed rate, this is known as the line rate and would be viewed through your CPE software or in your router configuration.
Your IP profile is always less than the line rate and is normal on any network.
The Upstream Test rate figure quoted will always be smaller than the assured rate profile. This is because in order for the throughput to reach its destination, it requires an overhead which explains the difference between the two.
Notes:
If your download speed lies in this range then your connection seems to be working fine.
Notes:
The Download Speed is the average rate that was achieved during this test.
Notes:
Your line is configured to the maximum rate that it can support or at your chosen fixed rate, this is known as the line rate and would be viewed through your CPE software or in your router configuration.
Your IP profile is always less than the line rate and is normal on any network.
I hope the profile can be nudged up to match BT's so I can reboot router if necessary.
Many thanks.
Re: IP Profile - 88.2% method
04-10-2011 11:45 AM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
P.S. It would help if you removed some of the blank lines in your post then I would be able to read it without needing to scroll
Re: IP Profile - 88.2% method
04-10-2011 11:53 AM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
I've put it up to 2000 now.
Jojo
Re: IP Profile - 88.2% method
04-10-2011 12:28 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Re: IP Profile - 88.2% method
04-10-2011 12:50 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
always in master socket, never use anything else.
cheers,
Podman
Re: IP Profile - 88.2% method
04-10-2011 2:10 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
jelv (a.k.a Spoon Whittler) Why I have left Plusnet (warning: long post!) Broadband: Andrews & Arnold Home::1 (FTTC 80/20) Line rental: Pulse 8 Home Line Rental (£14.40/month) Mobile: iD mobile (£4/month) |
Re: IP Profile - 88.2% method
04-10-2011 2:43 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Podman
Re: IP Profile - 88.2% method
04-10-2011 7:32 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
Re: IP Profile - 88.2% method
04-10-2011 7:51 PM
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report to Moderator
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Plusnet Community
- :
- Forum
- :
- Help with my Plusnet services
- :
- Broadband
- :
- Re: IP Profile - 88.2% method