Cannot Connect with sky Netgear DG834DT v1 after being flashed

[#1]

I have a SKY Netgear which I have flashed using Netgear Firmware and the Recovery Utility. All went well my laptop internet router reads it as NETGEAR. I have set up in http://192.168.0.1 log into it by admin and password. Entered username and password, done the encapsulation, clicked on Get Dynamically from ISP, Clicked on Get Automatically from ISP. Put in Micro-filter ADSL2.
But I get an error on internet bars on bottom panel, its got Yellow square with exlamation mark. Its say No internet access.
Please help?

[#2]

Sky have some customisation with their routers so flashing with normal Netgear firmware may muck this up.
See here -
http://www.kitz.co.uk/isp/sky_connection.htm

[#3]

So do you think after flashing the router, i will be unable to use it with plusnet?

[#4]

you should be able to... have you put your Plusnet credentials in the router?

[#5]

I have put my username@plusdsl.net and password but it says not internet access.
really love to sort this out.

[#6]

there should be a log within the router of it trying to connect, can you copy and past the contents of that?

[#7]

Quote from: mannyg

So do you think after flashing the router, i will be unable to use it with plusnet?

Sorry, I didn't realise you were trying to connect to Plusnet.  Yes this should be OK.
See settings here -

Quote

. Broadband Connection Settings These are the settings you'll need to connect to our broadband service with a compatible router. The terms used for these settings can vary, depending on the make and model of your router. We've included the most common alternatives below. Connection Settings Broadband Username/Login name username@plusdsl.net Connection Type / Encapsulation PPPoA /PPP over ATM Password The password you use to log in to this website Virtual Path Identifier (VPI) 0 Virtual Channel Identifier (VCI) 38 Multiplexing method VC Based / VCMUX / VC-Multiplexing Please note:     * The above table has everything you'll need to get connected with any ADSL compatible broadband router     * Some routers may ask you to enter other settings not mentioned above, you should be able to leave these as default or blank     * If your Plusnet broadband was activated before August 2002, your username may be username@plus.net rather than username@plusdsl.net     * Former Affinity Broadband customers will need to use username-pn@aihpipe.co.uk

[#8]

hi please see the attachments for the logs on the router, its like the DNS is not providing the router with an IP address

[#9]

It is not a DNS issue as you are not connected to the internet.  Please check all the settings in my previous post.
Here are my settings.  I do not have the same router as you but the settings are almost the same.

[#10]

on the front of the router what colour is the little 'i' light?

[#11]

the "i" light is green and sometimes flashes

[#12]

ok so that means that you have a connection to the internet, so it looks like your username and password could be wrong.
make sure it's <username>@plusdsl.net and check your password.