cancel
Showing results for 
Search instead for 
Did you mean: 

Pipes

dragona
Grafter
Posts: 207
Registered: 31-07-2007

Pipes

ey is there any way to force the connection to a specific pipe?

like my router could i set the default gateway to the IP of the juniper 655 meg pipe? if i had the ip ? i think im on 155 meg pipe 3
Quote

Tracing route to portal.plus.net [212.159.8.137]
over a maximum of 30 hops:

1 <1 ms <1 ms <1 ms mygateway.ar7 [192.168.1.1]
2 69 ms 20 ms 21 ms lo0.plusnet.pth-ag1.plus.net [195.166.128.11]
3 90 ms 66 ms 64 ms gi1-2.vlan3.pth-gw3.plus.net [212.159.1.2]
4 36 ms 71 ms 59 ms gi4-0-23.pth-gw2.plus.net [195.166.129.219]
5 167 ms 127 ms 124 ms atm0-1-0.ptb-gw1.plus.net [195.166.129.246]
6 78 ms 71 ms 113 ms vl4.pri.ptb-gw3.plus.net [195.166.129.226]
7 57 ms 163 ms 137 ms if2.ptb-al1.plus.net [195.166.129.39]
8 107 ms 54 ms 27 ms portal.plus.net [212.159.8.137]

Trace complete.

thanks for reading


Doesnt line number 3 that indicate my pipe or is it line 2?
2 REPLIES
Community Veteran
Posts: 14,469
Registered: 30-07-2007

Pipes

No you cannot determin the pipe that you use. This is something PlusNet control once you enter their network to make sure usage of the pipes is load-balanced, so no individual pipe is overloaded and thus all uses on that pipe getting reduced speeds.
dragona
Grafter
Posts: 207
Registered: 31-07-2007

Pipes

ah mkay thanks anyway