SSH

[#1]

Hi, Can the Thomson router support cli via SSH? I know telnet works but can SSH be enabled? I know the router boasts SSH encryption but I can't fine how to enable the SSH in the CLI

[#2]

oops... misread the post so my reply was wrong so deleted.
Why Can't I delete my own posts mods?

[#3]

No Problem, Any ideas?
RA config?
Service System?

[#4]

Quote from: Peter

oops... misread the post so my reply was wrong so deleted. Why Can't I delete my own posts mods?

That would be a legacy from a rouge mod, during my time (no names). Just use the report facility asking for it to be deleted.

[#5]

Anyone? Help please. If it is a no then it is not a problem at least I will know.

[#6]

i don't think you can.  telnet is all you get.

[#7]

Hi there,
The short answer is I'm not sure.
There's a CLI guide here which might help, but it's rather large. 

[#8]

This 'ere TG585v7 doesn't show ssh in it's server list so I guess you can't. This may be version dependent as things do get removed/added in different versions due to limited space.

{mike}=>service system list
Idx Name             Protocol         SrcPort  DstPort  Group            State   
---------------------------------------------------------------------------------
  1 CWMP-C           tcp                                                 disabled
  2 CWMP-S           tcp                       51005                     disabled
  3 DHCP-S           udp                       49152                     enabled 
  4 DNS-C            udp                       53                        enabled 
  5 DNS-S            udp                       53                        enabled 
  6 DYNAMIC_DNS                                                          enabled 
  7 FTP              tcp                       21                        enabled 
  8 HTTP             tcp                       80                        enabled 
  9 HTTPI            tcp                       8080                      disabled
 10 HTTPs            tcp                       443                       enabled 
 11 IGMP-Proxy       igmp                                                enabled 
 12 IP_COMMANDS                                                          enabled 
 13 MDAP             udp                       3235                      enabled 
 14 PING_RESPONDER   icmp                      8                         enabled 
 15 PPTP                                                                 enabled 
 16 SLA_ICMP_PING    icmp                      8                         disabled
 17 SLA_UDP_PING     udp                       7                         disabled
 18 SNTP             udp              123      123                       enabled 
 19 SSDP             udp                       1900                      enabled 
 20 TELNET           tcp                       23                        enabled 
 21 TFTP-C           udp                       69                        disabled

[#9]

Hi All, Thanks for the input. I have checked with BT and Thomson and the answer is in fact no. The CLI is only accessable via Telnet, my workaround is HTTPS to the GUI.
Thanks