right, the control restrictions are not working at all, suspect it's either because I have repeaters or because of the lock ups my router keeps locking up preventing me from logging on to it and seeing what is happening I am getting really bizarre connections issues, speed is high as per tests but some sites have become impossible to use but only wirelessly from certain repeaters dropping back from 10.2.5.2.FO to the 10.2.5.2 to see if that helps otherwise I will go back to 8.c.m.0 where I started Steve
oh great can't get the Thomson updater software to log onto the router it will happily connect to the two thompson repeaters I know the correct user name and password and cross referenced it by logging into the router normally but I still can't get into it! Grrrrrr, this firmware upgrade has done nothing but cause me problems Steve
Ok, can't log back into the router again at the moment so I will need to reset it to resolve that I am worried that if I do a hard reset so I can get back to the firmware update it still won't allow the firmware software to work and I will get more issues and could be locked out of it perminently anyone else had these problems? Steve
also seems to causing the DLNA Serviio server to keep dropping Going back to the 8.C.M.0 version but need to do a had reset of the router first This is a nightmare Steve
right did a hard reset and the thompson tool still can't log into the router using admin and serial number so i guess the firmware update has fubar'd the fireware update software? Steve
Take a look at [code=Telnet file=DLNA Server (Media Sharing) Not Discovered Across LAN / WLAN]. SOLVED This issue is present in firmware 8.2.7.7 Don't know about other firmware versions. Command Comments eth bridge igmpsnooping config View present state. If state=enabled then apply the fix eth bridge igmpsnooping config brname=bridge state=disabled Apply fix saveall Make permanent[/code] View source
hi, when the router locks it's log in (about 5 to 10 mins after a reset) Telnet also fails as for the DLNA issue, it's not constant It works fine and then at some point it stops being visible though I have never had it shut down whilst in opperation So I don't that this lack of discovery is the issue However, it does concern me that with the new firmware it locks you out after a while and the Thompson update software no longer works. Steve
